氣相二氧化硅在低粘樹脂中的沉降問題？？？?。?！

wonder

<>氣相二氧化硅在低粘樹脂中的沉降問題？？？！??！ 如何解決/？？請教！</P>

sio2liu

<B>以下是引用<I>wonder</I>在2005-8-30 16:46:04的發言：</B>


<>就一般的通用樹脂，黏度在160~180CPS（brookfield 2#/60)或更低?？ú┨氐臍庀喽趸瑁≈x謝你們的回信！</P>

<>歡迎來電垂詢交流


</P>[em07]

[此貼子已經被作者于2005-9-3 21:39:54編輯過]

kinwdc

可能和氣相二氧化硅的品級   表面處理有關系~~     方便的話  請告知是那種樹脂  目前用那種氣相二氧化硅

sio2liu

一起等待樓主翔示…………

wonder

<>就一般的通用樹脂，黏度在160~180CPS（brookfield 2#/60)或更低?？ú┨氐臍庀喽趸?！謝謝你們的回信！</P>

link

BYK&reg;-405 Rheology additive for solvent-based systems. The additive is most suitable for coatings based on polyesters, acrylics and alkyds which contain fumed silica. The fumed silica must be at least partially hydrophilic. BYK&reg;-405 facilitates the incorporation of the silica, prevents its separation, increases and stabilizes the thixotropic behavior. It contributes to gloss clarity improvement and humidity resistance of fumed silica containing coatings. Thixotropic resin systems can show additional thixotropy with the post-addition of BYK&reg;-405. Composition  Solution of polyhydroxycarboxylic acid amides
Solvents  Xylene / Alkylbenzenes / Isobutanol 5 / 4 / 1
Dosage (Additive as supplied)  20-40 % upon fumed silica
Typical Physical Data  Non-volatile matter: 52 %

link

<>BYK-405</P><>可以增加并且穩定體系的觸變行為。。。。</P><>不知道有沒有用。。。呵呵</P>[em01]